Using FaceTime for a TV recording

A test with your interviewee / correspondent is always good in advance, to check for any issues with their internet signal and setup; also, to brief them on what they’ll be able to see and hear.

Interviewee / correspondent: To be interviewed using FaceTime, you’ll need an Apple ID, but if you don’t have one already, you can set one up here. The applications you need for FaceTime are built in to contemporary Apple devices such as phones and laptops, but if using a mobile, remember to hold your phone horizontally for widescreen (rather than sending in tall, narrow video).

TIP: The interviewee / correspondent should use an earpiece where possible, to reduce doubling up of sound, and an external microphone for best audio quality.

FaceTime operator in the Gallery: At the Mac station in the TV Gallery, open the Contacts application (hover at the bottom of the screen until a dock of applications appears, and click the brown address book icon). In Contacts > Accounts you can call up your own Apple ID, as long as you’re wary of the sync options (as not to fill the Mac with your personal documents etc.) and remember to remove the account afterwards.

If they’re not listed already, you’ll need to add your interviewee as a new contact, so got to File > New Card (or press Command + N). Enter their details, including the e-mail address or phone number you’ll be using to contact them on FaceTime. Then click “Done” to save. When you’re ready to call, click the FaceTime video camera icon near the “Call” section of their contact details. When the call has connected, if the application hasn’t already filled the screen, click the full screen icon to maximize the call.

On the Vision Mixer and the iPad sound mixer, the FaceTime computer (since it might be used for other tools to feed into bulletins) is labelled “Mac”.

Call your interviewee to have them ready ahead of the recording. Check that the interviewee can hear both from the presenter/s and from the talkback mic in the TV Gallery, and that the presenter/s can hear the interviewee. The talkback mic can be used to cue the interviewee (e.g. advise them when the interview’s coming up). If doing a video call, check that you can see the interviewee, and that s/he is shown on the “Mac” feed of the TV Gallery’s big multi-view monitor.

Mix the levels on the iPad as usual. Use the “Mac” channel on the “MAIN” bus to alter the level of the interviewee which goes to the final TV mix. Use Bus 5 to alter the levels fed to the presenter/s. Use Bus 6 to alter the levels the interviewee hears themselves – just presenters, VT and talkback mic on Bus 6. Due to low-level cross signals that can bleed to other channels, it’s best for the FaceTime operator to mute the audio on the Mac when the FaceTime call isn’t being featured in the bulletin.

Call up the necessary graphic from the Caspar VT software, e.g. the “JUS, live, Sheffield” graphic – this can be dragged into the running order. The graphic needs to be played out by the VT operator by pressing F2 as normal, and left on for the duration of the FaceTime call.

During the FaceTime call, use the macros on the vision mixer to switch sources as usual (e.g. “Cam 3 to Mac”).

After the interview, the Vision Mixer should switch away from the “Mac” feed, after which the VT operator should press F1 to remove the graphics, the sound mixer should turn the sound down on the “Mac” feed, and the FaceTime operator should also mute the sound on the Mac.

Skype: To use  Skype instead of FaceTime, see the Skype instructions instead.

 

Comments

comments

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload the CAPTCHA.